Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 706)

678 Unified IP MIB Reference
53-1002549-02
Standard traps
Pseudo wire traps
The following are the PW traps.
NOTE
The following traps are supported on the Brocade NetIron XMR, Brocade NetIron MLX, and Brocade
MLXe devices.
Additional MPLS-related traps are listed in “MPLS notifications” on page 708, and “MPLS LSP
notification” on page 708.
alarmRisingThreshold
1.3.6.1.2.1.16.3.1.1.7 A threshold for the sampled statistic. This object generates an event when the
current sampled value is greater than or equal to this threshold, and the value
at the last sampling interval was less than this threshold. This object also
generates an event if the first sample after this entry becomes valid is greater
than or equal to this threshold and the associated alarmStartupAlarm is equal
to risingAlarm(1) or risingOrFallingAlarm(3).
After a rising event is generated, another such event will not be generated until
the sampled value falls below this threshold and reaches the
alarmFallingThreshold.
alarmFallingThreshold
1.3.6.1.2.1.16.3.1.1.8 A threshold for the sampled statistic. This object generates an event when the
current sampled value is less than or equal to this threshold, and the value at
the last sampling interval was greater than this threshold. This object also
generates an event if the first sample after this entry becomes valid is less than
or equal to this threshold and the associated alarmStartupAlarm is equal to
fallingAlarm(2) or risingOrFallingAlarm(3).
After a falling event is generated, another such event will not be generated until
the sampled value rises above this threshold and reaches the
alarmRisingThreshold.
Trap name and
number Supported? Varbind Description
pwDown
brcdIp.3.1.2.0.1 Yes pwOperStatus (for start
of range)
pwOperStatus (for end
of range)
fdryPWServiceType This notification is generated when the pwOperStatus
object for one or more contiguous entries in pwTable
are about to enter the down(2) state from some other
state. The included values of pwOperStatus must all be
set equal to this down(2) state.
On the Brocade NetIron MLX, Brocade MLXe, Brocade
NetIron XMR, Brocade NetIron CES, and Brocade
NetIron CER series devices, this object is available for
VPLS, VLL, and VLL local services.