Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 206)

178 Unified IP MIB Reference
53-1002549-02
System CPU utilization table
snAgentCpuUtilCpuId
brcdIp.1.1.2.11.1.1.2
Syntax: Integer32 Read-only The ID of the CPU:
•
For non-VM1/WSM management module, there is one CPU.
•
For VM1/WSM, there is one management CPU and three slave
CPUs. The management CPU could be turned off.
•
For POS and ATM, there is no management CPU but two slave
CPUs.
•
The ID for the management CPU is 1. A value of 2 and greater
identifies the slave CPUs.
snAgentCpuUtilInterval
brcdIp.1.1.2.11.1.1.3
Syntax: Integer32 Read-only The value, in seconds, for this utilization. For both management and
slave CPUs, utilizations for 1 sec, 5 sec, 60 sec, and 300 sec intervals
are displayed.
snAgentCpuUtilValue
brcdIp.1.1.2.11.1.1.4
Syntax: Gauge32
NOTE: This object is
not supported
for Brocade
NetIron XMR
and Brocade
NetIron MLX
devices,
FastIron GS,
and FastIron SX.
It is not
supported on
Brocade MLXe
devices. Use the
snAgentCpuUtil
Percent and
snAgentCpuUtil
100thPercent
objects instead.
Read-only The statistical CPU utilization in units of one-hundredth of a percent.
Name, OID, and syntax Access Description