beautypg.com

Vlan layer 2 switch mib definition, Vlan by port information table, Snvlanbyporttable – Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) User Manual

Page 321: Snvlanbyportentry, Snvlanbyportvlanindex, Snvlanbyportvlanid, Snvlanbyportportmask, Chapter 23, Chapter

background image

Unified IP MIB Reference

293

53-1002549-02

Chapter

23

VLAN Layer 2 Switch MIB Definition

In this chapter

VLAN by port information table. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 293

VLAN by port membership table. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 297

Port VLAN configuration table. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 298

VLAN by protocol configuration table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 302

VLAN by IP subnet configuration table. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 303

VLAN by IPX network configuration table . . . . . . . . . . . . . . . . . . . . . . . . . . . 305

VLAN by AppleTalk cable configuration table . . . . . . . . . . . . . . . . . . . . . . . 307

VLAN extended statistics. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 308

VLAN by port information table

The following table applies to a Layer 2 device if the object snSwGroupOperMode is configured with
a value of vlanByPort(2), allowing switch ports to be configured with a VLAN ID. Each VLAN switch
port could have a number of VLAN IDs.

NOTE

The following table is not supported on the Brocade NetIron MLX, Brocade MLXe, Brocade NetIron
XMR, Brocade NetIron CES, and Brocade NetIron CER series devices.

Name, OID, and syntax

Access

Description

snVLanByPortTable
brcdIp.1.1.3.2.1

None

The VLAN by port information table for Layer 2 Switches.

snVLanByPortEntry
brcdIp.1.1.3.2.1.1

None

An entry in the VLAN by port information table.

snVLanByPortVLanIndex
brcdIp.1.1.3.2.1.1.1
Syntax: Integer

Read-only

Shows the index to this table.
The VLAN ID number must not be greater than the value of the
object. Each VLAN identifier can be a member of multiple ports.

snVLanByPortVLanId
brcdIp.1.1.3.2.1.1.2
Syntax: Integer

Read-write

The VLAN ID index to the table. Each VLAN identifier can be a
member of multiple ports.
Valid values: 1 – 4095

snVLanByPortPortMask
brcdIp.1.1.3.2.1.1.3
Syntax: PortMask

Read-write

Shows the standalone switch VLAN port membership. This object
was obsoleted for Chassis devices.