Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 567)

Unified IP MIB Reference 539
53-1002549-02
IP RIP port configuration table
IP RIP port configuration table
The IP RIP port configuration table contains the configuration of RIP on a particular interface.
Before you can use this table, RIP must be enabled in the device and must be configured with
permit and deny commands.
NOTE
The IP RIP MIBs are not supported on the Brocade MLXe router, Brocade NetIron MLX, Brocade
NetIron XMR, Brocade NetIron CES, and Brocade NetIron CER series devices.
snRtIpRipDistance
brcdIp.1.2.3.1.8
Syntax: Integer Read-write Shows the administrative distance of this filter.
Valid values: 1 – 255
snRtIpRipEcmpEnable
brcdIp.1.2.3.1.9
Syntax: RtrStatus
NOTE: This MIB object is
supported on the
Brocade FastIron
devices.
Read-write Enables or disables ECMP for IP RIP:
•
0 – Disables ECMP
•
1 – Enables ECMP
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
snRtIpRipPortConfigTable
brcdIp.1.2.3.2 None The IP RIP port configuration table.
snRtIpRipPortConfigPortIndex
brcdIp.1.2.3.2.1.1
Syntax: PortIndex Read-only The port index for an entry in the IP RIP port configuration table.
snRtIpRipPortVersion
brcdIp.1.2.3.2.1.2
Syntax: Integer Read-write Specifies the IP RIP version on this port:
•
disabled(0) – RIP is disabled on this port.
•
v1Only(1) – RIP version 1 only.
•
v2Only(2) – RIP version 2 only.
•
v1CompatibleV2(3) – RIP version 2 is compatible with
version 1.
snRtIpRipPortPoisonReverse
brcdIp.1.2.3.2.1.3
Syntax: Integer Read-write Indicates if poison reverse is enabled:
•
disabled(0)
•
enabled(1)
Poison reverse prevents routing loops and slow convergence
within the network.
snRtIpRipPortLearnDefault
brcdIp.1.2.3.2.1.4
Syntax: Integer Read-write Indicates if the ability to learn advertised routes is enabled on
the interface:
•
disabled(0)
•
enabled(1)