Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 420)

392 Unified IP MIB Reference
53-1002549-02
IPv4 ACL table
snAgAclTos
brcdIp.1.2.2.15.2.1.17
Syntax: TosValue Read-write Applies only to extended ACLs.
Indicates the type of service a packet must have to be
denied or permitted:
•
normal(0) – The ACL matches packets that have the
normal TOS. If TOS is not defined, packets are
matched to this value.
•
minMonetaryCost(1) – The ACL matches packets that
have the minimum monetary cost TOS.
•
maxReliability(2) – The ACL matches packets that
have the maximum reliability TOS.
•
maxThroughput(4) – The ACL matches packets that
have the maximum throughput TOS.
•
minDelay(8) – The ACL matches packets that have
the minimum delay TOS.
snAgAclEstablished
brcdIp.1.2.2.15.2.1.18
Syntax: Integer Read-write Applies only to extended ACLs.
Enables or disables the filtering of established TCP
packets that have the ACK or RESET flag turned on. This
additional filter only applies to TCP transport protocol:
•
disabled(0)
•
enabled(1)
snAgAclLogOption
brcdIp.1.2.2.15.2.1.19
Syntax: TruthVal Read-write Determines if ACL matches are logged:
•
false(0) – Do not log ACL matches.
•
true(1) – Log ACL matches.
snAgAclStandardFlag
brcdIp.1.2.2.15.2.1.20
Syntax: TruthVal Read-write Indicates if this is a standard ACL:
•
false(0) – The ACL is an extended ACL.
•
true(1) – The ACL is a standard ACL.
snAgAclRowStatus
brcdIp.1.2.2.15.2.1.21
Syntax: SnRowStatus Read-write Creates or deletes an ACL entry:
•
other(1)
•
valid(2)
•
delete(3)
•
create(4)
snAgAclFlowCounter
brcdIp.1.2.2.15.2.1.22
Syntax: Counter64 Read-only Shows an approximate count of flows that match the
individual ACL entry.
snAgAclPacketCounter
brcdIp.1.2.2.15.2.1.23
Syntax: Counter64 Read-only Shows the number of packets that matched the ACL entry.
snAgAclComments
brcdIp.1.2.2.15.2.1.24
Syntax: DisplayString Read-write Indicates the description of an individual ACL entry.
snAgAclIpPriority
brcdIp.1.2.2.15.2.1.25
Syntax: Integer Read-write Indicates the QoS priority option for this ACL. This priority
assigns traffic that matches the ACL to a
hardware-forwarding queue. In addition to changing the
internal forwarding priority, if the outgoing interface is an
802.1Q interface, this option maps the specified priority to
its equivalent 802.1p (CoS) priority and marks the packet
with the new 802.1p priority.
NOTE: This option applies only to 10 Gigabit Ethernet
modules.
Name, OID, and syntax Access Description