Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 549)

Unified IP MIB Reference 521
53-1002549-02
OSPF virtual neighbor table
OSPF virtual neighbor table
The OSPF virtual neighbor table describes all virtual neighbors. Because virtual links are
configured in the virtual interface table, this table is read-only.
Reference: RFC 1583 “OSPF Version 2”, section 15 Virtual Links.
snOspfNbrEvents
brcdIp.1.2.4.7.1.1.9
Syntax: Counter Read-only Shows the number of times this neighbor’s state has changed state, or the
number of times an error occurred.
snOspfNbrLsRetrans
QLen
brcdIp.1.2.4.7.1.1.10
Syntax: Gauge32 Read-only Specifies the interval between the retransmission of link-state
advertisements to router adjacencies for this interface. The range is from 0
through 3600 seconds.
Default: 5 seconds
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
snOspfVirtNbrTable
brcdIp.1.2.4.8.1 None The OSPF virtual neighbor table.
snOspfVirtNbrEntryIndex
brcdIp.1.2.4.8.1.1.1
Syntax: Integer32 Read-only The ID of an entry in the OSPF virtual neighbor table.
snOspfVirtNbrArea
brcdIp.1.2.4.8.1.1.2
Syntax: AreaID Read-only Shows the ID of the transit area. The format is defined in the
“snOspfVirtNbrAreaIdFormat” object.
snOspfVirtNbrRtrId
brcdIp.1.2.4.8.1.1.3
Syntax: RouterID Read-only Identifies the IP address of the neighboring router in the autonomous
system (AS). This is a 32-bit integer.
snOspfVirtNbrIpAddr
brcdIp.1.2.4.8.1.1.4
Syntax: IpAddress Read-only Shows the IP address of this virtual neighbor.
snOspfVirtNbrOptions
brcdIp.1.2.4.8.1.1.5
Syntax: Integer32 Read-only Shows a bit map that corresponds to the neighbor’s options field.
Thus, Bit 1, if set, indicates that the neighbor supports Type of Service
routing; if zero, no metrics other than TOS 0 are in use by the
neighbor.