Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 622)

594 Unified IP MIB Reference
53-1002549-02
General MPLS objects
General MPLS objects
The following table contains the general MPLS MIB objects.
MPLS LSP table
The following table contains objects for the MPLS LSPs table.
Name Access Supported?
vplsPwBindIndex
brcdIp.3.4.1.1.4.1.1
Syntax: PWIndexType Read-only Yes
PwIndex of corresponding PWTable.
One VPLS may have multiple PWTable
entries.
vplsPwBindConfigType
brcdIp.3.4.1.1.4.1.2
Syntax: Integer Read-only Yes
Always manual(1)
vplsPwBindType
brcdIp.3.4.1.1.4.1.3
Syntax: Integer Read-only Yes
Always mesh(1)
vplsPwBindRowStatus
brcdIp.3.4.1.1.4.1.4
Syntax: RowStatus Read-only Yes.
•
active(1) - If PW state is
operational
•
not-in-service(2) - If PW is not
operational
vplsPwBindStorageType
brcdIp.3.4.1.1.4.1.5
Syntax: StorageType Read-only Yes
Only permanent(4) is supported
Name, OID, and syntax Access Description
mplsVersion
brcdIp.1.2.15.1.1.1
Syntax: Unsigned32 Read-only The MPLS version number.
mplsConfiguredLsps
brcdIp.1.2.15.1.2.1
Syntax: Unsigned32 Read-only The number of configured LSPs. This is calculated by adding the
number of RSVPs and statically configured label switched paths
(LSPs).
mplsActiveLsps
brcdIp.1.2.15.1.2.2
Syntax: Unsigned32 Read-only The number of active LSPs. This is calculated by adding the number of
RSVPs, LDPs, and statically configured LSPs.
Name, OID, and syntax Access Description
mplsLspTable
brcdIp.1.2.15.1.2.3 None The MPLS LSP table.
mplsLspSignalingProto
brcdIp.1.2.15.1.2.3.1.1
Syntax: Integer None MPLS signaling protocol used by this LSP:
•
ldp(1)
•
rsvp(2)