Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 53)

Unified IP MIB Reference 25
53-1002549-02
RFC 2932: IPv4 Multicast Routing MIB
ipMRouteNextHopTable
(IP multicast route next hop table)
In this table, “NextHop” refers to the downstream traffic.
The following CLI commands display information about the objects in the IP multicast route next
hop table:
• show ip pim mcache
• show ip pim neighbor
The SET request is not supported for this table.
.
ipMRouteInterfaceTable
(IP multicast route interface table)
This is the IP multicast route table for interfaces.
The show ip pim interface command is used to display information about this table.
The following interface-level commands are used to create an entry to the IP multicast route
interface table:
• ip pim
• ip pim-sparse
• ip pim ttl-threshold
Object Object identifier Supported?
ipMRouteNextHopGroup 1.3.6.1.2.1.83.1.1.3.1.1 Yes
ipMRouteNextHopSource 1.3.6.1.2.1.83.1.1.3.1.2 Yes
ipMRouteNextHopSourceMask 1.3.6.1.2.1.83.1.1.3.1.3 Yes
ipMRouteNextHopIfIndex 1.3.6.1.2.1.83.1.1.3.1.4 Yes
ipMRouteNextHopAddress 1.3.6.1.2.1.83.1.1.3.1.5 Yes
ipMRouteNextHopState 1.3.6.1.2.1.83.1.1.3.1.6 Yes, but read-only. Always shows
forwarding(2).
ipMRouteNextHopUpTime 1.3.6.1.2.1.83.1.1.3.1.7 Yes, but read-only.
ipMRouteNextHopExpiryTime 1.3.6.1.2.1.83.1.1.3.1.8 Yes, but read-only.
ipMRouteNextHopClosestMember
Hop 1.3.6.1.2.1.83.1.1.3.1.9 Yes, but read-only.
ipMRouteNextHopProtocol 1.3.6.1.2.1.83.1.1.3.1.10 Yes, but read-only.
ipMRouteNextHopPkts 1.3.6.1.2.1.83.1.1.3.1.11 No
NOTE: This object is not supported
on the Brocade MLXe,
Brocade NetIron MLX,
Brocade NetIron XMR,
Brocade NetIron CES, and
Brocade NetIron CER series
devices.