Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 153)

Unified IP MIB Reference 125
53-1002549-02
Flash card
Flash card
The following objects manage the flash cards in all the devices.
snChasActualTemperature
brcdIp.1.1.1.1.18
Syntax: Integer Read-only Applies only to management modules with temperature sensors.
Shows the temperature of the chassis. Each unit is 0.5º Celsius.
NOTE: If you are comparing this value to the value you get when you
enter a show chassis command on the CLI, divide this value by
2. The result is the actual temperature you see in the CLI. This
was done intentionally to represent tenth decimal values in
SNMP, as SNMP can only report INTEGER values.
Valid values: 110 – 250
snChasWarningTemperatur
e
brcdIp.1.1.1.1.19
Syntax: Integer Read/writ
e Applies only to management modules with temperature sensors.
Shows the threshold for the warning temperature. When the actual
temperature exceeds this value, the switch sends a temperature
warning trap. Each unit is 0.5º Celsius.
Valid values: 0 – 250
NOTE: If you compare the value with the value while entering the show
chassis command and divide the value by 2. The result is the
warning (or shutdown) temperature. This is done intentionally
to represent the tenth decimal values in the SNMP, as the
SNMP can only report the INTEGER values.
snChasShutdownTemperat
ure
brcdIp.1.1.1.1.20
Syntax: Integer Read/writ
e Applies only to management modules with temperature sensors.
Shows the temperature threshold that triggers the device to shut
down. When the actual temperature exceeds this value, the switch
shuts down a portion of the hardware to cool down the device. Each
unit is 0.5º Celsius.
Valid values: 0 – 250
NOTE: If you compare the value with the value while entering the show
chassis command and divide the value by 2. The result is the
warning (or shutdown) temperature. This is done intentionally
to represent the tenth decimal values in the SNMP, as the
SNMP can only report the INTEGER values.
snChasEnableTempWarnTr
ap
brcdIp.1.1.1.1.21
Syntax: Integer Read-write Indicates if the SNMP agent process has been enabled to generate
temperature warning traps:
•
disabled(0)
•
enabled(1)
Default: enabled(1)
Name, OID, and syntax Access Description