Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 445)

Unified IP MIB Reference 417
53-1002549-02
VRRP and VRRP-E virtual router configuration table
snVrrpVirRtr2CurrPriorit
y
brcdIp.1.2.12.5.1.1.5
Syntax: Integer Read-only The current VRRP or VRRP-E priority of this Layer 3 Switch for the VRID.
The current priority can differ from the configured priority for the
following reasons:
•
The VRID is still in the initialization stage and has not become a
master or backup yet. In this case, the current priority is 0.
•
The VRID is configured with track ports and the link on a tracked
interface has gone down.
A higher number indicates a higher priority.
This object is adjusted dynamically when the tracked port first changes
from up to down.
Valid values: 1 – 254
snVrrpVirRtr2HelloInt
brcdIp.1.2.12.5.1.1.6
Syntax: Integer Read-write Shows the number of seconds between hello advertisements from the
master and the backup.
Valid values: 1 – 84
Default: 1 second.
snVrrpVirRtr2DeadInt
brcdIp.1.2.12.5.1.1.7
Syntax: Integer Read-write Applies only to VRRP or VRRP-E backups.
It shows the configured value for the dead interval. The dead interval
is the number of seconds that a backup router waits for a hello
message from the VRID master before determining that the master is
no longer active.
If the Master does not send a hello message before the dead interval
expires, the backups negotiate (compare priorities) to select a new
master for the VRID.
Valid values: 1 – 84
Default: 0, which means that this object has not been configured.
snVrrpVirRtr2PreemptM
ode
brcdIp.1.2.12.5.1.1.8
Syntax: Integer Read-write Indicates if the backup preempt mode is enabled:
•
disabled(0) – Prohibit preemption.
•
enabled(1) – Allow preemption.
Default: enabled(1)
The backup preempt mode prevents a backup router with a higher
VRRP priority from taking control of the VRID from another backup
router that has a lower priority, but has already assumed control of the
VRID.
snVrrpVirRtr2State
brcdIp.1.2.12.5.1.1.9
Syntax: Integer Read-only Specifies the VRRP or VRRP-E router’s interface state:
•
init(0) – Initialization state
•
master(1) – Master state
•
backup(2) – Backup state
snVrrpVirRtr2IpAddrMas
k
brcdIp.1.2.12.5.1.1.10
Syntax: OCTET STRING Read-write The number of IP addresses of this virtual router of this interface.
snVrrpVirRtr2Activate
brcdIp.1.2.12.5.1.1.11
Syntax: Integer Read-write Indicates if VRRP or VRRP-E router is enabled:
•
disabled(0) – The router is deactivated.
•
enabled(1) – The router has been activated.
snVrrpVirRtr2BackupInt
brcdIp.1.2.12.5.1.1.12
Syntax: Integer Read-write Time interval between backup routers hello message advertisements
in seconds. The default is 60 seconds.
Name, OID, and syntax Access Description