Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 592)

564 Unified IP MIB Reference
53-1002549-02
PIM-SM
PIM-SM
The following tables are available for the PIM Sparse feature.
NOTE
The following tables in this section are not supported on the Brocade MLXe router, Brocade NetIron
MLX, Brocade NetIron XMR, Brocade NetIron CES, and Brocade NetIron CER series devices.
PIM Sparse: candidate BSR table
The candidate Bootstrap Router (BSR) table contains information about BSRs that are candidates
to become the active BSR for the domain. The BSR distributes Rendezvous Point (RP) information
to the other PIM Sparse routers within the domain. Each PIM Sparse domain has one active BSR.
For redundancy, you can configure ports on multiple routers as candidate BSRs. The PIM Sparse
protocol uses an election process to select one of the candidate BSRs as the active BSR for the
domain. The BSR with the highest BSR priority is elected. If the priorities result in a tie, the
candidate BSR interface with the highest IP address is elected.
PIM RP set table
The PIM RP set table contains information about candidate Rendezvous Points (RPs) for IP
multicast groups. When the local Layer 3 Switch is the BSR, this information is obtained from the
advertisements received from the candidate-RP. When the local Layer 3 Switch is not the BSR, this
information is obtained from the received RP-Set messages.
Name, OID, and syntax Access Description
snPimJoinPruneInterval
brcdIp.1.2.9.2.1
Syntax: Integer Read-write The default interval in seconds at which periodic PIM Sparse join and
prune messages are to be sent. These messages inform other PIM
Sparse Layer 3 Switches about clients who want to become receivers
(join) or stop being receivers (prune) for PIM Sparse groups.
Valid values: 10 – 3600 seconds
Default: 60 seconds
Name, OID, and syntax Access Description
snPimCandidateBSRTable
brcdIp.1.2.9.2.2 None The candidate bootstrap router (BSR) table.
snPimCandidateBSRPortID
brcdIp.1.2.9.2.2.1.1
Syntax: Integer32 Read-write Identifies the IP address of the PIM interface:
•
Bit 0 to bit 7 – Port number
•
Bit 8 to bit 11 – Slot number
snPimCandidateBSRIPAddress
brcdIp.1.2.9.2.2.1.2
Syntax: IpAddress Read-only Shows the unicast IP address of the candidate BSR.
snPimCandidateBSRHashMaskLen
brcdIp.1.2.9.2.2.1.3
Syntax: Integer Read-write Indicates the hash mask value for this Layer 3 Switch as a
candidate bootstrap router.
Valid values: 1 – 32
snPimCandidateBSRPreference
brcdIp.1.2.9.2.2.1.4
Syntax: Integer Read-write Indicates the preference value for this Layer 3 Switch as a
candidate bootstrap router.
Valid values: 0 – 255
Default: 100