Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 187)

Unified IP MIB Reference 159
53-1002549-02
SP boot sequence table
NOTE
Ensure that each entry is unique. It is possible to create entries with the same instructions by
creating a new sequence index. Duplicate instructions may cause loops.
SP boot sequence table
Name, OID, and syntax Access Description
snAgBootSeqTable
brcdIp.1.1.2.4.1 None Identifies the boot sequence table.
snAgBootSeqIndex
brcdIp.1.1.2.4.1.1.1
Syntax: Integer Read-only The index to the boot sequence table.
snAgBootSeqInstruction
brcdIp.1.1.2.4.1.1.2
Syntax: Integer Read-write Shows the image from which the device will boot:
•
fromPrimaryFlash(1)
•
fromSecondaryFlash(2)
•
fromTftpServer(3)
•
fromBootpServer(4)
snAgBootSeqIpAddr
brcdIp.1.1.2.4.1.1.3
Syntax: IpAddress Read-write If the object “snAgBootSeqInstruction” is set to “fromTftpServer”, this
object shows the IP address of the TFTP server that contains the image
that will be used in the boot.
snAgBootSeqFilename
brcdIp.1.1.2.4.1.1.4
Syntax: DisplayString Read-write Shows the name of the image filename on the TFTP server that will be
used in the boot. This object applies only if the object
“snAgBootSeqInstruction” is set to “fromTftpServer”. This object can
have up to 32 characters.
snAgBootSeqRowStatus
brcdIp.1.1.2.4.1.1.5
Syntax: Integer Read-write Creates or deletes an entry in the boot sequence table:
•
other(1)
•
valid(2)
•
delete(3)
•
create(4)
Name, OID, and syntax Access Description
snAgSpBootSeqTable
brcdIp.1.1.2.4.2 None Identifies the SP boot sequence table.
snAgSpBootSeqSpNumb
er
brcdIp.1.1.2.4.2.1.1 None The slot number of a switch processor module for which this boot
sequence applies. Setting value 0 applies to all SP modules. Index 0 is
valid only for setting to simplify the set operation for all the modules.
snAgSpBootSeqIndex
brcdIp.1.1.2.4.2.1.2
Syntax: Integer None The index to the boot sequence table.