Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 212)

184 Unified IP MIB Reference
53-1002549-02
Switch group configuration
snSwGroupSwitchAgeTime
brcdIp.1.1.3.1.5
Syntax: Integer32 Read-write Sets the aging period for ports on the device, defining how long a port
address remains active in the address table.
Valid values: 0 = no aging, or 67 – 65535 seconds
Default: 300 seconds
snVLanGroupVlanCurEntry
brcdIp.1.1.3.1.6
Syntax: Integer32 Read-only Shows the number of VLANs that are currently configured.
snVLanGroupSetAllVLan
brcdIp.1.1.3.1.7
Syntax: Integer32
NOTE: This object is not
supported on the
Brocade MLXe
router, Brocade
NetIron MLX,
Brocade NetIron
XMR, Brocade
NetIron CES, and
Brocade NetIron
CER series devices.
Read-write Shows the VLAN index of a particular entry in snVLanByPortTable
(snVLanByPortVLanIndex). All the attributes of the row except for
PortMask will be used to set the same attributes for the entire VLAN
group. VLanId and PortMask must be set for the particular entry prior
to setting this object. Switch software will be based on this VLAN
information to set the entire VLAN.
NOTE: All the intended attributes of the given row of the table (given
VLAN) must be set prior setting this object. When this object is
set, Set-All-VLAN action takes place simultaneously. The
previous setting is overwritten by the new one.
snSwPortSetAll
brcdIp.1.1.3.1.8
Syntax: Integer32
NOTE: This object is not
supported on the
Brocade MLXe
router, Brocade
NetIron MLX,
Brocade NetIron
XMR, Brocade
NetIron CES, and
Brocade NetIron
CER series devices.
Read-write The value of this object is the index number of the snSwPortInfoTable
(snSwPortInfoPortIndex). The objects snSwPortInfoMonitorMode,
snSwPortInfoTagType, snSwPortInfoChnMode, snSwPortInfoSpeed,
snSwPortInfoAdminStatus are all the read-write attributes of that row
of the table. They will be used to set the same attributes for all the
ports in the system.
NOTE: Before setting this object, all the intended attributes of the
given row of the table must be set. Otherwise, the current data
of the row will be used to set the entire port table. The
previous setting will be overwritten by the new one.
snFdbTableCurEntry
brcdIp.1.1.3.1.9
Syntax: Integer32 Read-only Shows the total number of entries in the Filtering Databse (FDB) that
are configured currently.
snFdbTableStationFlush
brcdIp.1.1.3.1.10
Syntax: Integer Read-write Shows the state of the flush operation for the FDB table.
The following value can be written:
•
flush(3) – Perform the flush operation. After the flush operation
starts, any new flush request is rejected until the operation is
complete or failed.
The following values can only be read:
•
normal(1) – Normal state
•
error(2) – Operation failed
•
flushing(4) – Operation is in process
Name, OID, and syntax Access Description