Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 559)

Unified IP MIB Reference 531
53-1002549-02
OSPF routing information table
OSPF routing information table
The OSPF routing information table contains information on the OSPF Area Border Router (ABR) or
Autonomous System Boundary Router (ASBR) routing.
NOTE
The following table is not supported on the Brocade MLXe router, Brocade NetIron XMR, Brocade
NetIron MLX, Brocade NetIron CES, and Brocade NetIron CER series devices.
snOspfVirtIfStatusMd5Auth
Key
brcdIp.1.2.4.13.1.1.13
Syntax: OCTET STRING Read-only Specifies the MD5 authentication key. The value of this object is
encrypted and included in each OSPF packet transmitted.
If the value of this object is shorter than 16 octets, the agent will
left-adjust and zero-fill the key to equal 16 octets.
When read, snOspfIfMd5AuthKey always returns a blank.
snOspfVirtIfStatusMd5Activ
ationWaitTime
brcdIp.1.2.4.13.1.1.14
Syntax: Integer Read-only Determines when a newly configured MD5 authentication key is valid.
This parameter provides a graceful transition from one MD5 key to
another without disturbing the network. All new packets transmitted
after the key activation wait time interval use the newly configured
MD5 key. OSPF packets that contain the old MD5 key are accepted
for up to five minutes after the new MD5 key is in operation. The
range for the key activation wait time is from 0 through 14400
seconds.
snOspfVirtIfStatusAreaIdFor
mat
brcdIp.1.2.4.13.1.1.15
Syntax: Integer Read-only Specifies the format of how Area ID will be entered in the
“snOspfVirtIfStatusAreaID” object:
•
integer(0) – Integer
•
ipAddress(1) – IP address
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
snOspfRoutingInfoTable
brcdIp.1.2.4.14.1 None The OSPF routing information table.
snOspfRoutingInfoIndex
brcdIp.1.2.4.14.1.1.1
Syntax: Integer32 Read-only The ID of an entry in this table.
snOspfRoutingInfoRouterID
brcdIp.1.2.4.14.1.1.2
Syntax: RouterID Read-only Shows the ID or IP address of the destination router.
snOspfRoutingInfoRouterType
brcdIp.1.2.4.14.1.1.3
Syntax: Integer Read-only Shows what router type the destination router is:
•
abr(1) – Area Border Router
•
asbr(2) – Autonomous System Border Router
•
abrANDasbr(3) – Area Border and Autonomous System
Border Router