Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 188)

160 Unified IP MIB Reference
53-1002549-02
Encoded octet strings table
Encoded octet strings table
Each row in the Encoded Octet Strings (EOS) table represents a fragmented configuration file data
packet, including its checksum. An SNMP SET represents a configuration file download process,
while an SNMP GET represents a configuration file upload.
This action occurs only if the SNMP-SET of snAgCfgLoad command is sent along with this table
consecutively. Consecutive SETs are performed until the network management system has no
more packets to send. Likewise, consecutive GETs are done until the agent has no more packets to
send.
The applicable snAgCfgLoad command value is as follows:
• uploadFromFlashToNMS(23)
• downloadToFlashFromNMS(24)
• uploadFromDramToNMS(25)
• downloadToDramFromNMS(26)
NOTE
This table is not supported on the Brocade MLXe, Brocade NetIron XMR, Brocade NetIron MLX,
Brocade NetIron CES, and Brocade NetIron CER series devices
.
snAgSpBootSeqInstructio
n
brcdIp.1.1.2.4.2.1.3
Syntax: Integer Read-write Shows the image from which the device will boot:
•
fromSpPrimaryFlash(1)
•
fromSpSecondaryFlash(2)
•
fromMpPrimaryFlash(3)
•
fromMpSecondaryFlash(4)
•
fromPcmciaCard1(5)
•
fromPcmciaCard2(6)
•
fromTftpServer(7)
•
interactively(8)
snAgSpBootSeqIpAddr
brcdIp.1.1.2.4.2.1.4
Syntax: IpAddress Read-write If the object “snAgBootSeqInstruction” is set to “fromTftpServer”, this
object shows the IP address of the TFTP server that contains the image
that will be used in the boot.
snAgSpBootSeqFilename
brcdIp.1.1.2.4.2.1.5
Syntax: DisplayString Read-write Shows the name of the image filename on the TFTP server that will be
used in the boot. This object applies only if the object
“snAgBootSeqInstruction” is set to “fromTftpServer”. This object can
have up to 32 characters.
snAgSpBootSeqRowStat
us
brcdIp.1.1.2.4.2.1.6
Syntax: Integer Read-write Creates or deletes an entry in the boot sequence table:
•
valid(1)
•
delete(2)
•
create(3)
Name, OID, and syntax Access Description