IAI America ERC3 - Manual (Page 82)

Chapter 2 Installation
2.2 Installation and Storage Environment
72
[2] Storage • Preservation Environment
䎃
(1) Actuator
The storage • preservation environment should be similar to the installation environment. In
addition, make sure condensation will not occur when the actuator is to be stored or preserved
for a long period of time. Unless specified, we do not include drying agents when shipping the
actuator. If you are storing the actuator in an environment where condensation might occur, you
must treat the entire shipping box, or treat the actuator itself after unpacking, to prevent
condensation. The unit can withstand temperatures up to 60qC during a short
storage/preservation period, but only up to 50qC if the storage/preservation period is longer
than one month.
The actuator should be lying flat during storage • preservation.
If the actuator is to be stored in a packed state, follow the specified actuator position if
indicated.
䎃
(2) PIO Converter • Quick Teach
Storage and preservation environment follows the installation environment. However, the
surrounding temperature should be from -20 to 70qC and the relative humidity to be 85%RH at
maximum. Especially in a long-term storage, consider to avoid condensation of surrounding air.
Unless specified, we do not include drying agents when shipping the actuator. If you are storing
the actuator in an environment where condensation might occur, you must treat the entire
shipping box, or treat the actuator itself after unpacking, to prevent condensation.
䎃
䎃
䎃