IAI America ERC3 - Manual (Page 392)

Chapter 8
Actuator Maintenance Check
8.6 Grease Supply
382
3) On the rod sliding part, apply grease by hand.
4) After applying the grease, move the rod back and forth so the grease spreads out evenly.
For some of the low lead actuators, the rod would not move manually with hand. Move it with
JOG operation of the controller.
5) Reinstall the thin-head screw with a 1.5mm hex wrench.
Warning: When supplying grease, do not attempt to use spray oil. Make sure to use spray
grease. Also make sure to make the spraying time 1 second or less, and do not
make it longer than 1 second in continuous or supply twice in quick cycle. If
applying excess grease, the oil may flow to the electrical components and may
cause an error operation.
Caution: In case the grease got into your eye, immediately go see the doctor to get
appropriate care.
After finishing the grease supply work, wash your hands carefully with water and
soap to rinse the grease off.