IAI America ERC3 - Manual (Page 79)

Chapter 2 Installation
2.1
Transportation
69
Chapter 2 Installation
2.1 Transportation
[1] Handling of Actuator, PIO Converter and Quick Teach
Unless otherwise specified, the actuators are wrapped individually when the product is shipped
out. Also, PIO Converter and Quick Teach are packaged separately.
䎃
(1) Handling the Packed Unit
• Do not damage or drop. The package is not applied with any special treatment that enables it
to resist an impact caused by a drop or crash.
• Transport a heavy package with at least more than two operators. Consider an appropriate
method for transportation.
• Keep the unit in horizontal orientation when placing it on the ground or transporting. Follow the
instruction if there is any for the packaging condition.
• Do not step or sit on the package.
• Do not put any load that may cause a deformation or breakage of the package.
(2) Handling the Actuator After Unpacking
• Do not carry an actuator by a cable or attempt to move it by pulling the cable.
䎃
䎃
䎃
• When carrying the actuator main unit, hold the base part for the slider type and the frame of
the body for the rod type.
• When carrying the actuator, exercise caution not to bump it against nearby objects or
structures.
• Do not give any excessive force to any of the sections in the actuator.
• Handle with care on the operation panel of the quick teach since it is easy to get scratched.
䎃