IAI America ERC3 - Manual (Page 313)

Chapter 6
Adjustment of Operation
6.3 I/O Parameter
303
6.3 I/O Parameter
Parameter data should be set appropriately according to the applicaiton requirements.
When a change is required to the parameters, make sure to back up the data before the change
so the settings can be returned anytime.
With using PC software, it is able to store the backup to the PC.
Leave a memo if using the teaching pendant.
For a quick data recovery after such works as investigation on malfunction and replacement of
ERC3 and PIO converter, it is also recommended to back up or take a note on the parameter
after the setting change.
The change to the parameters will be activated after they are edited, written to the FeRAM, then
either software reset or reboot of the power. It will not be active only with writing on the teaching
tool.
Warning: Establishment of parameter setting gives a great influence to operation.
Wrongly established setting could cause not only an operation error or
malfunction, but also it is very dangerous.
Settings at the delivery enable the product to operate standardly.
Understand very well about the control logic of ERC3 and PIO converter
if making a change or performing a setting suitable to the system.
Please contact us if you have anything unclear.
Do not attempt to turn OFF the power to the ERC3 or PIO converter
while writing the parameters.