Configuring a paging line – H3C Technologies H3C MSR 50 User Manual
Page 756
371
Item Description
DTMF Detection Sensitivity
Level
Set the DTMF detection sensitivity level.
•
Low—In this mode, the reliability is high, but DTMF tones might fail to be
detected.
•
High—In this mode, the reliability is low and detection errors might occur.
Status
•
Enable.
•
Disable.
Configuring a paging line
Select Voice Management > Line Management from the navigation tree, and then click the
icon of
the paging line to be configured to access the audio interface configuration page, as shown in
Figure 751 Configuring SIC-audio page interface
Table 278 Configuration items
Item Description
Line Description
Specify the description of the paging line.
Voice Interface Output
Gain
When a relatively small voice signal power is needed on the output line, increase the
voice output gain value.
IMPORTANT:
Gain adjustment might lead to call failures. H3C recommends not adjusting the gain. If
necessary, do it with the guidance of technical personnel.
Silent Mode
•
Enable.
•
Disable.
By default, the silent mode is disabled.
IMPORTANT:
If the silent mode is enabled on an audio interface, the interface cannot transmit data.