H3C Technologies H3C MSR 50 - Manual (Page 108)

87
Figure 61 Enabling 802.11g radio
Verifying the configuration
If you select Interface Setup > Wireless > Summary from the navigation tree, and click the Client tab, you
can view the online clients.
Configuration guidelines
Follow these guidelines when you configure a wireless service:
• Select a correct district code.
• Make sure the radio unit is enabled.
Access service-based VLAN configuration example
Network requirements
An AP can provide multiple wireless access services. Different wireless access services can use different
wireless security policies, and can be bound to different VLANs to implement wireless access user
isolation.
As shown in
Figure 62 , configure wireless VLANs to satisfy the following requirements:
• Set up a wireless access service named research, and configure it to use the PSK authentication.
Clients that access the wireless network are in VLAN 2.
• Set up a wireless access service named office, and configure it to use the clear text authentication.
Clients that access the wireless network are in VLAN 3.
Figure 62 Network diagram
Configuration procedure
1. Configure a wireless service named research.
a. Select Interface Setup > Wireless > Access Service from the navigation tree.
b. Click Create.
c. Configure the name of the wireless service as research, and select the wireless service type
crypto.
IP network
Client：0014-6c8a-43ff
SSID：research
SSID：office
Client：0040-96b3-8a77
VLAN：2
VLAN：3
Router