H3C Technologies H3C MSR 50 - Manual (Page 153)

132
Item Description
Rate
Set the rate of the clients.
• If you select the static mode, static rate is displayed, and the rate is
the bandwidth of each client.
• If you select the dynamic mode, share rate is displayed, and the rate
is the total bandwidth of all clients.
Wireless QoS configuration example
CAC service configuration example
Network requirements
As shown in Figure 128 , an AP with WMM enabled accesses the Ethernet. Enable CAC for the AC-VO
and AC-VI queues of the clients of the fat AP. Use the user number-based admission policy to limit the
number of access users to 10, so that the clients using high-priority queues (including the AC-VO and
AC-VI queues) can be guaranteed of enough bandwidth.
Figure 128 Network diagram
Configuration procedure
1. Configure the access service:
For related configurations, see "
Wireless access service configuration examples ." You can strictly
follow the steps in the related configuration example to configure the wireless service.
2. Configure wireless QoS:
a. Select Interface Setup > Wireless > Wireless QoS from the navigation tree.
b. Click the QoS Service tab. Make sure WMM is enabled.
Figure 129 Enabling wireless QoS
c. Select the radio unit to be configured in the list.
d. Click the corresponding icon in the Operation column.
e. In the Client EDCA list, select the priority type (AC_VO is taken for example here) to be
modified.
f. Click the corresponding icon in the Operation column.
g. Select Enable from the CAC list.