H3C Technologies H3C MSR 50 User Manual
Page 270
249
Figure 251 Subnet limit setting
Table 117 Configuration items
Item Description
Start Address
Set the address range of the subnet where rate limit is to be performed.
End Address
Interface
Specify the interface to which the subnet limit is to be applied.
CIR
Set the average traffic rate allowed.
Type
Set the rate limit method:
•
Share—Limits the total rate of traffic for all IP addresses on the subnet, and
dynamically allocates bandwidth to an IP address based on traffic size.
•
Per IP—Individually limits the rate of traffic of each IP address on the subnet to the
configured rate.
Direction
Set the direction where the rate limit applies:
•
Download—Limits the rate of incoming packets of the interface based on their
destination IP addresses.
•
Upload—Limits the rate of outgoing packets of the interface based on their source
IP addresses.