Configuration considerations, Configuration procedure – H3C Technologies H3C MSR 50 User Manual
Page 211
190
Figure 198 Network diagram
Configuration considerations
1.
Configure a default route with Router B as the next hop on Router A.
2.
On Router B, configure one static route with Router A as the next hop and the other with Router C
as the next hop.
3.
Configure a default route with Router B as the next hop on Router C.
Configuration procedure
1.
Configure the IP addresses of the interfaces. (Details not shown.)
2.
Configure a default route on Router A:
a.
Select Advanced > Route Setup from the navigation tree of Router A.
b.
Click the Create tab.
c.
Enter 0.0.0.0 for Destination IP Address, 0 for Mask, and 1.1.4.2 for Next Hop.
d.
Click Apply.
Figure 199 Configuring a default route on Router A
The newly created static route is listed at the lower part of the page.