Advanced queue configuration example, Network requirements, Configuration procedure – H3C Technologies H3C MSR 50 User Manual
Page 279
258
2.
Enter 2.1.1.1 in the Start Address field.
3.
Enter 2.1.1.100 in the End Address field.
4.
Select interface Ethernet 1/1.
5.
Enter 5 in the CIR field.
6.
Select Per IP in the Type list.
7.
Select Upload from the Direction list.
8.
Click Apply.
Advanced queue configuration example
Network requirements
As shown in
, data traffic from Router C reaches Router D by the way of Router A and then
Router B. The data traffic from Router C is classified into three classes based on DSCP fields of IP packets.
Configure advanced queue to perform the following actions:
•
Perform AF for traffic with the DSCP fields AF11 and AF22 (DSCP values 10 and 18), and set the
minimum bandwidth to 40 kbps.
•
Perform EF for traffic with the DSCP field EF (DSCP value 46), and set the maximum bandwidth to
240 kbps.
Before performing the configuration, make sure:
•
The route from Router C to Router D through Router A and Router B is reachable.
•
The DSCP fields have been set for the traffic before the traffic enters Router A.
Figure 258 Network diagram
Configuration procedure
1.
Configure Router A:
# Perform AF for traffic with DSCP fields AF11 and AF21.
a.
Select Advance > QoS Setup > Advanced Queue from the navigation tree, and click Add on the
displayed page
.