H3C Technologies H3C MSR 50 - Manual (Page 522)

137
Figure 530 System time configuration page
Table 198 Configuration items
Item Description
Automatic
Synchronizat
ion
NTP Server 1.
Enable clock automatic synchronization with an NTP server. You can
specify two NTP servers by entering their IP addresses. NTP Server 1 is the
primary and NTP Server 2 is the secondary.
IMPORTANT:
• With automatic synchronization configured, the device periodically
synchronizes its time with the NTP server. If the synchronization fails, the
system uses the manually configured time. After the synchronization
recovers, the system uses the synchronized time.
• The IP address of an NTP server is a host address, and cannot be a
broadcast or a multicast address, or the IP address of the local clock.
• If the system time of the NTP server is ahead of the system time of the
device, and the difference between them exceeds the Web idle time
specified on the device, all online Web users are logged out because of
timeout.
NTP Server 2.
Manual Setup
Set the system time manually.
You can type the system date and time in the box, or select the date and time
in the calendar, as shown in Figure 531 .
• Click Today. The date in the calendar becomes the local date, and the
time in the calendar does not change.
• Select the year, month, date, and time, and then click OK.