H3C Technologies H3C MSR 50 - Manual (Page 363)

342
a. Select User Management > User for Device Management from the navigation tree.
b. Click Add in the right pane.
c. Enter hello@bbb as the username.
d. Enter abc for the password and confirm the password.
e. Select Telnet as the service type.
f. Enter 3 for the EXEC privilege level.
This parameter identifies the privilege level of the Telnet user after login. The value is 0 by
default.
g. Enter 192.168.1.0 for the start IP address of the hosts and 192.168.1.255 as the end IP
address of the host.
h. Click Add.
i. Click OK.
Figure 343 Adding a user account
Configuring the RADIUS server on IMC
This example assumes that the RADIUS server runs on IMC PLAT 3.20-R2602 and IMC UAM
3.60-E6102.
1. Add the router to IMC as an access device:
a. Log in to IMC:
b. Click the Service tab.
c. Select Access Service > Service Configuration from the navigation tree.
d. Click Add.
e. Enter expert as the shared key for authentication and accounting.
f. Enter 1812 and 1813 as the ports for authentication and accounting, respectively.
g. Select Device Management Service as the service type.
h. Select H3C as the access device type.
i. Select the access device from the device list, or manually add the device with the IP address of
10.1.1.2.
The IP address of the access device must be the same as the source IP address of the RADIUS
packets sent from the router. By default, the source IP address of a RADIUS packet is the IP
address of the sending interface.