Displaying the active route table, Ipv4 static route configuration example, Network requirements – H3C Technologies H3C MSR 50 User Manual
Page 210
189
Displaying the active route table
Select Advanced > Route Setup from the navigation tree to display the Summary tab.
Figure 197 Active route table
Table 101 Field description
Field Description
Destination IP Address
Destination IP address of the route.
Mask
Mask of the destination IP address.
Protocol
Routing protocol that discovered the route, including static route, direct
route, and various dynamic routing protocols.
Preference
Preference for the route.
Next Hop
Next hop address of the route.
Interface
Output interface of the route. Packets destined for the destination IP address
are forwarded out of the interface.
IPv4 static route configuration example
Network requirements
The routers' interfaces and the hosts' IP addresses and masks are shown in
. You must
configure static routes on the routers for any two hosts to communicate with each other.