Configuring router b – H3C Technologies H3C MSR 50 User Manual
Page 415
30
4.
Configure a static route from Router A through interface Tunnel0 to Group 2:
a.
Select Advanced > Route Setup from the navigation tree.
b.
Click the Create tab and then perform the configurations shown in
c.
Enter 10.1.3.0 as the destination IP address.
d.
Enter mask 24.
e.
Select the box before Interface, and then select egress interface Tunnel0.
f.
Click Apply.
Figure 396 Adding a static route from Router A through interface Tunnel 0 to Group 2
Configuring Router B
1.
Configure an IPv4 address for interface Ethernet 0/0:
a.
Select Interface Setup > WAN Interface Setup from the navigation tree.
b.
Click the
icon for interface Ethernet 0/0 and then perform the configurations shown
c.
Select Manual for Connect Mode.
d.
Enter IP address 10.1.3.1.
e.
Select IP mask 24 (255.255.255.0).
f.
Click Confirm.