H3C Technologies H3C MSR 50 - Manual (Page 191)

170
Step Remarks
3. Adding a blacklist entry manually
You can add blacklist entries manually, or enable the blacklist function
globally, configure the scanning attack protection function, and
enable the blacklist function for scanning attack protection to allow the
device to add the IP addresses of detected scanning attackers to the
blacklist automatically. For configuration of scanning attack
protection, see " Configuring intrusion detection ."
By default, no blacklist entry exists.
IMPORTANT:
Modifying an automatically added entry will change the type of the
entry to Manual.
4. Viewing blacklist entries Optional.
Enabling the blacklist function
From the navigation tree, select Security Setup > Attack Defend > Blacklist to enter the page shown
in
Figure 171 , where all manually configured or automatically generated blacklist entries are listed. Select
the box before Enable Blacklist and click Apply to enable the blacklist filtering function.
Figure 171 Blacklist page
Adding a blacklist entry manually
On the blacklist page shown in Figure 171 , click Add to configure a blacklist entry, as shown in Figure
172 .