H3C Technologies H3C MSR 50 - Manual (Page 520)

135
Setting the super password
Users of the management level can specify the password for a lower-level user to switch from the current
access level to the management level. If no such a password is configured, the switchover fails.
To set the super password for switching to the management level:
1. From the navigation tree, select System Management > Users.
2. Click the Super Password tab.
The super password configuration page appears.
3. Configure the super password as described in Table 197 .
4. Click Apply.
Figure 528 Super password configuration page
Table 197 Configuration items
Item Description
Create/Remove
Set the operation type:
• Create—Configure or modify the super password.
• Remove—Remove the current super password.
Password Set the password for a user to switch to the management level.
Confirm Password
Enter the same password again. Otherwise, the system prompts that the two passwords
entered are not consistent when you apply the configuration.
Switching to the management level
This function enables a user to switch the current user level to the management level.
Before switching, make sure the super password is already configured. A user cannot switch to the
management level without a super password.
The access level switchover of a user is valid for the current login only. The access level configured for the
user is not changed. When the user re-logs in to the Web interface, the access level of the user is still the
original level.
To switch the user access level to the management level:
1. From the navigation tree, select System Management > Users.