Configuration procedure, Verifying the configuration, N in – H3C Technologies H3C MSR 50 User Manual
Page 156: Figure 134
135
Figure 134 Network diagram
Configuration procedure
1.
Configure the wireless service:
For the configuration procedure, see "
Wireless access service configuration examples
." You can
strictly follow the related configuration example to configure the wireless service.
2.
Configure dynamic rate limiting:
a.
Select Interface Setup > Wireless > Wireless QoS from the navigation tree.
b.
Click Client Rate Limit.
c.
Click Add.
d.
On the page that appears, select service2 from the Wireless Service list, select both from the
direction list, select dynamic from the mode list, enter 8000 in the share rate field, and click
Apply.
Figure 135 Configuring dynamic rate limiting
Verifying the configuration
Verify the following:
•
When only Client 1 accesses the WLAN through SSID service2, its traffic can pass through at a rate
as high as 8000 kbps.
•
When both Client 1 and Client 2 access the WLAN through SSID service2, their traffic flows can
each pass through at a rate as high as 4000 kbps.