H3C Technologies H3C MSR 50 - Manual (Page 116)

95
Figure 77 Enabling the wireless service
b. Select the mac-auth option.
c. Click Enable.
4. (Optional.) Enable 802.11g radio. By default, the 802.11g radio is enabled.
Select Interface Setup > Wireless > Radio from the navigation tree to enter the Radio page. Make
sure 802.11g is enabled.
Configuring the RADIUS server (IMCv3)
The following takes the IMC (IMC PLAT 3.20-R2602 and IMC UAM 3.60-E6102) as an example to
illustrate the basic configuration of the RADIUS server.
To configure the RADIUS server:
1. Add an access device:
a. Click the Service tab in the IMC Platform.
b. Select Access Service > Access Device from the navigation tree.
c. Click Add.
d. On the page that appears, enter expert as the Shared Key, add ports 1812, and 1813 for
Authentication Port and Accounting Port, select LAN Access Service for Service Type, select
H3C for Access Device Type, select or manually add the access device with the IP address
10.18.1.1, and click OK.
Figure 78 Adding an access device
2. Add a service: