Configuring the snmp nms, Verifying the configuration – H3C Technologies H3C MSR 50 User Manual
Page 536
151
6.
Type prikey in the field of Privacy Password.
7.
Type 1.1.1.2 in the field of Trusted Host.
8.
Type 1.1.1.2 in the field of Trap Target Host Address/Domain.
9.
Click Apply.
Configuring the SNMP NMS
The configuration on the NMS must be consistent with that on the agent. Otherwise, you cannot perform
corresponding operations.
1.
Specify the SNMP version for the NMS as v3.
2.
Create an SNMP user user1.
3.
Enable both authentication and privacy functions
4.
Use MD5 for authentication and DES56 for encryption.
5.
Set the authentication key to authkey and the privacy key to prikey.
For more information about configuring the NMS, see the NMS manual.
Verifying the configuration
•
After the configuration, an SNMP connection is established between the NMS and the agent. The
NMS can get and configure the values of some parameters on the agent through MIB nodes.
•
Disable or enable an idle interface on the device, and the NMS receives the corresponding trap.