H3C Technologies H3C MSR 50 - Manual (Page 296)

275
Item Description
UDP Port
Set UDP port number.
IMPORTANT:
The default port number is 162, which is the SNMP-specified port
used for receiving traps on the NMS. Generally (such as using IMC
or MIB Browser as the NMS), you can use the default port number.
To change this parameter to another value, make sure the
configuration is the same with that on the NMS.
Security Model
Select the security model, the SNMP version.
IMPORTANT:
The security model must be the same as that running on the NMS.
Otherwise, the NMS cannot receive any trap.
Security Level
Set the authentication and privacy mode for SNMP traps when
the security model is selected as v3. The available security levels
are: no authentication no privacy, authentication but no privacy,
and authentication and privacy.
If you select v1 or v2c in the Security Model list, the security level
can only be no authentication no privacy, and cannot be
modified.
Displaying SNMP packet statistics
Select Advanced > SNMP from the navigation tree to enter the Setup tab page. On the lower part of the
page, you can view the SNMP statistics, as shown in
Figure 277 .
Figure 277 SNMP Statistics page