H3C Technologies H3C MSR 50 - Manual (Page 167)

146
Configuring a DMZ host
Creating a DMZ host
1. From the navigation tree, select NAT Configuration > NAT Configuration.
2. Click the DMZ HOST tab.
The DMZ host configuration page appears.
Figure 147 Creating a DMZ host
3. Configure the parameters as described in Table 86 .
4. Click Add.
Table 86 Configuration items
Item Description
Host IP Address Specify the internal IP address of a DMZ host.
Global IP Address Specify the external IP address of a DMZ host.
Enabling DMZ host on an interface
From the navigation tree, select NAT Configuration > NAT Configuration and click the DMZ HOST tab to
enter the DMZ host configuration page as shown in Figure 147 . You can enable or disable DMZ host on
interfaces.
• The icon indicates that DMZ host is disabled on the corresponding interface. Click the Enable
link next to the interface to enable DMZ host on the interface.
• The icon indicates that DMZ host is enabled on the corresponding interface. Click the Disable
link next to the interface to disable DMZ host on the interface.