H3C Technologies H3C MSR 50 - Manual (Page 131)

110
Verifying the configuration
On the AP shown in Figure 102 , select Interface Setup > Wireless Service > Summary > Client from the
navigation tree to enter the page shown in Figure 106 , where you can check that the router is online.
Figure 106 Making sure the workgroup bridge is online
• You can see that the client with MAC address 0014-6c8a-43ff and the router with MAC address
000f-e2333-5510 have been successfully associated with the AP.
• The wired devices on the right (such as printers and PCs) can access the wireless network through
the router.
Configuration guidelines
As shown in Figure 107 , if the router uses two radio interfaces at the same time, the client connecting to
radio 2 can access the AP through the router.
Figure 107 Network diagram
Configuring radios
802.11b/g operates in 2.4 GHz band, 802.11a in 5 GHz band, and 802.11n in both 2.4 GHz and 5
GHz bands. Each band can be divided into multiple channels for wireless communication. You can
configure and adjust the channels to achieve optimal performance.
To configure a radio, select Interface Setup > Wireless > Radio from the navigation tree to enter the Radio
page, select the desired AP, and click the
icon to enter the page for AP radio setup page.
Internet
Gateway AP
Client
Radio1
Client
Ra
dio
2
Rad
io2