H3C Technologies H3C MSR 50 - Manual (Page 362)

341
• Add an account on the RADIUS server, with the username and password being hello@bbb and abc.
If the user passes authentication, it is assigned a privilege level of 3.
Figure 341 Network diagram
Configuring the RADIUS server on CAMS
This example assumes that the RADIUS server runs on CAMS Server Version 2.10-R0210.
1. Add the router to CAMS as an access device:
f. Log in to CAMS.
g. Select System Management > System Configuration from the navigation tree.
h. In the System Configuration page, click Modify for Access Device.
i. Click Add.
j. Enter 10.1.1.2 as the IP address of the device.
k. Set both the shared key for authentication and accounting to expert.
l. Select Device Management Service as the service type.
m. Specify the ports for authentication and accounting as 1812 and 1813, respectively.
n. Select Extensible Protocol as the protocol type.
o. Select Standard as the RADIUS packet type.
p. Click OK.
Figure 342 Adding an access device
2. Add a user account: