H3C Technologies H3C MSR 50 - Manual (Page 155)

134
Figure 132 Network diagram
Configuration procedure
1. Configure the access service:
For the configuration procedure, see "
Wireless access service configuration examples ." You can
strictly follow the related configuration example to configure the wireless service.
2. Configure static rate limiting:
a. Select Interface Setup > Wireless > Wireless QoS from the navigation tree.
b. Click Client Rate Limit.
c. Click Add.
d. On the page that appears, select service1 from the Wireless Service list, select inbound from
the direction list, select static from the mode list, enter 128000 in the static rate field, and click
Apply.
Figure 133 Configuring static rate limiting
Verifying the configuration
• Client 1 and Client 2 access the WLAN through an SSID named service1.
• Check that traffic from Client 1 is rate limited to around 128 kbps, so is traffic from Client 2.
Dynamic rate limiting configuration example
Network requirements
As shown in Figure 134 , clients access the WLAN through a SSID named service2. Configure all clients
to share 8000 kbps of bandwidth in any direction.