Configuring the snmp agent, Configuring the snmp nms – H3C Technologies H3C MSR 50 User Manual
Page 534
149
Figure 539 Network diagram
Configuring the SNMP agent
1.
Select System Management > SNMP from the navigation tree, and then perform configuration as
.
Figure 540 Configuring the SNMP agent
2.
Select the Enable option.
3.
Select the SNMPv1 & v2 option.
4.
Type readonly in the field of Read Password.
5.
Type read&write in the field of Read & Write Password.
6.
Type read&write in the field of Trap Password.
7.
Type 1.1.1.2 in the field of Trap Target Host Address/Domain.
8.
Click Apply.
Configuring the SNMP NMS
The configuration on the NMS must be consistent with that on the agent. Otherwise, you cannot perform
corresponding operations.
1.
Configure the SNMP version for the NMS as v1 or v2c.
2.
Create a read-only community public and set the read-only password to readonly.
3.
Create a read and write community and set the read and write password to readwrite.
For more information about configuring the NMS, see the NMS manual.