HP Array Controller HSG V8.7 Software User Manual
Page 70
2–16
HSG80 User’s Guide
Use the following steps to connect a single, nonredundant controller to
the host using one hub:
1. Stop all I/O from the host to its devices on the bus to which you are
connecting the controller.
2. Connect the Fibre Channel cable from Port 1 on the controller to Port 1
of the hub.
For this configuration, set Port 2 off-line using the SET
THIS_CONTROLLER PORT_2_TOPOLOGY=OFFLINE command.
See Appendix B, “CLI Commands,” for details about the SET
command.
3. Follow the procedures in the Getting Started Guide for connecting the
Fibre Channel cable from the hub to your host system.
4. Route and tie the cables as desired.
5. Restart the I/O from the host. Some operating systems may require you
to restart the host to see the devices attached to the new controller.
Table 2–2 Key to Figure 2–5 Cabling for Single Configuration
(optical)
Item Description
Part
No.
1
Single Controller
70–33259–xx
2
.5 M Fibre Channel Optic cable
1 M Fibre Channel Optic cable
2 M Fibre Channel Optic cable
3 M Fibre Channel Optic cable
5 M Fibre Channel Optic cable
10 M Fibre Channel Optic cable
20 M Fibre Channel Optic cable
30 M Fibre Channel Optic cable
50 M Fibre Channel Optic cable
100 M Fibre Channel Optic cable
200 M Fibre Channel Optic cable
400 M Fibre Channel Optic cable
17–04820–01
17–04820–02
17–04820–03
17–04820–04
17–04820–05
17–04820–06
17–04820–07
17–04820–08
17–04820–09
17–04820–10
17–04820–11
17–04820–12
3
12-Port Fibre Channel HUB
DHGGA-CA