HP Array Controller HSG V8.7 Software - Manual (Page 327)

CLI Commands B–55
DELETE connections
Deletes a host connection entry from the table of known connections.
This command deletes a specified connection from the table of known
connections maintained by the controller.
The table of known host connections is maintained in the controllers
NVRAM. Once a connection is added to the table, it stays there, even
if the physical connection between host adapter and controller port is
severed. The only way to remove a connection from the table is
through the DELETE connections command.
DELETE connections removes the connection from the table whether
or not the host adapter is still physically connected to a controlled port.
Note A connection that has access path explicity enabled on a unit
cannot be deleted. Access path is enabled through the ADD UNIT or
SET UNIT commands. If access path is generically enabled for all
connections (ENABLE_ACCESS_PATH= ALL), then any or all
connections can be deleted.
Syntax
DELETE connection name
Parameters
connection name
The name given to the host connection. The connection name is one of
the following:
n The default name assigned to the host connection when it was
physically connected to the controller port. Default names are of
the form !NEWCONnn.
n The name given through the RENAME command.
n The name given through the ADD CONNECTIONS command.