HP Array Controller HSG V8.7 Software - Manual (Page 486)

D–52 HSG80 User’s Guide
02F60103 An invalid modification to the no_interlock VSI flag was attempted.
n Last Failure Parameter [0] contains the nv_index of the config on which the
problem was found.
n Last Failure Parameter [1] contains modification flag.
n Last Failure Parameter [2] contains the current value of the no_interlock flag.
If the modification flag is 1, then an attempt was being made to set the no_interlock
flag, and the no_interlock flag was not clear at the time. If the modification flag is 0,
then an attempt was being made to clear the no_interlock flag, and the no_interlock
flag was not set (== 1) at the time.
02F70100 During boot testing, one or more device ports (SCSI) were found to be bad. Due to a
problem in the SYMBIOS 770 chip, the diagnostic may occasionally fail the port even
though the hardware is OKAY. A reboot should clear up the problem. If the port is
actually broken, logic to detect a loop that repeatedly causes the same bugcheck will
cause a halt.
02F80103 An attempt was made to bring a unit online when the cache manager says that a
member CLD was not in the appropriate state.
n Last Failure Parameter [0] contains the nv_index of the config on which the
problem was found.
n Last Failure Parameter [1] contains the map type of that config.
n Last Failure Parameter [2] contains the value from CACHE$CHECK_CID that
was not acceptable.
02F90100 A call to EXEC$ALLOCATE_MEM_ZEROED failed to return memory when
allocating structures for read ahead caching.
02FA0100 A read ahead caching data structure (RADD) is inconsistent.
02FB2084 A processor interrupt was generated by the controller’s XOR engine (FX), indicating
an unrecoverable error condition.
n Last Failure Parameter [0] contains the FX Control and Status Register (CSR).
n Last Failure Parameter [1] contains the FX DMA Indirect List Pointer register
(DILP).
n Last Failure Parameter [2] contains the FX DMA Page Address register
(DADDR).
n Last Failure Parameter [3] contains the FX DMA Command and control register
(DCMD).
Table D–3 Last Failure Codes (Continued)
Code Description