HP Array Controller HSG V8.7 Software - Manual (Page 572)

I–24 HSG80 User’s Guide
Single-controller configuration
connecting to the host using one hub, 2–14
ECB, 1–28
installing
cache module, 5–7
controller, 5–4
DIMMs, 5–44
GLM, 5–33
removing
cache module, 5–6
controller, 5–3
DIMMs, 5–43
GLM, 5–32
replacing
cache module, 5–6
controller, 5–3
controller and its cache module, 5–2
DIMMs, 5–42
ECB, 5–27
ECB with cabinet powered off, 5–29
ECB with cabinet powered on, 5–28
GLM, 5–32
I/O module, 5–39
PCMCIA card, 5–46
PVA module, 5–34
PVA module in the first expansion enclo-
sure, 5–36
PVA module in the master enclosure, 5–34
PVA module in the second expansion enclo-
sure, 5–36
replacing modules, 5–2
upgrading to dual-redundant controller
configuration, 6–16
Single-disk units
backing up, 3–19
configuring with CLI, 3–60
displaying switches, 3–66
SIZE
CREATE_PARTITION, B–51
Software
patches, 6–6
upgrading, 6–2
Software patches
deleting, 6–7
installing, 6–6
listing, 6–9
listing, installing, deleting, 6–6
Solid OCP
events
controller termination, 4–14
Sparesets
adding disk drives using CLI, 3–63
adding to configuration, B–23
AUTOSPARE, 3–65
removing a disk drive, B–61
removing disk drives using CLI, 3–64
Speed. See transfer rate
Spontaneous event log
no controller termination, 4–16
Starting the subsystem, 5–50
Status
device ports, 4–28
devices, 4–26
host port, 4–24
units, 4–29
Storage requirements, determining, 3–7
Storage subsystem
typical installation, 1–2
Storageset map, 3–32
Storageset member
replacing, 5–47
Storageset profile, 3–5, A–3
Storageset switches, 3–39
changing switches, 3–39
enabling switches, 3–39
Storagesets
adding devices with the CONFIG utility, 1–15
attributes, 3–8
backing up, 3–19
backing up data with the Clone utility, 1–16
changing switches, 3–66
comparison, 3–8
configuring using CLI, 3–55
creating a profile, 3–5