HP Array Controller HSG V8.7 Software User Manual

Page 429

LED Codes

C–5

■● ● ❍ ❍ ❍ ❍

An unexpected bugcheck occurred
before subsystem initialization
completed

An unexpected Last Failure
occurred during initialization

Reinsert controller. If that does not
correct the problem, reset the controller.
If the error persists, try resetting the
controller again, and replace it if no
change occurs.

■● ❍ ●● ● ●

Memory module has illegal
DIMM configuration

Verify that DIMMs are installed as
shown in Figure 1-3 on page 1-7.

■● ❍ ●● ● ❍

Multiple cabinets have the same
SCSI ID

More than one cabinet have the
same SCSI ID

Reconfigure PVA ID to uniquely-
identify each cabinet in the subsystem.
The cabinet with the controllers must
be set to
PVA ID 0; additional cabinets must use
PVA IDs 2 and 3. If error continues
after PVA settings are unique, replace
each PVA module one at a time. Check
cabinet if problem remains.

■● ❍ ●● ❍ ●

All master cabinet SCSI buses are
not set to ID 0

Set PVA ID to 0 for the cabinet with the
controllers. If problem persists, try the
following repair actions:
1. Replace the PVA module
2. Replace the EMU
3. Remove all devices
4. Replace the cabinet

■● ❍ ●● ❍ ❍

Cabinet IO termination power out
of range

Faulty or missing IO module
causes cabinet IO termination
power to be out of range

Ensure that all of the cabinet’s device
SCSI buses have an I/O module. If
problem persists, replace the failed I/O
module.

■● ❍ ●❍ ●●

Jumpers not terminators found on
backplane

One or more SCSI bus terminators
are either missing from the
backplane or broken

Ensure that cabinet’s SCSI bus
terminators are installed and that there
are no jumpers. Replace the failed
terminator if the problem continues.

Table C–1

Solid OCP Patterns (Continued)

Pattern

OCP

Code

Error

Repair Action