HP Array Controller HSG V8.7 Software - Manual (Page 416)

B–144 HSG80 User’s Guide
device-type
Specifies the type of devices you want to be displayed. Valid choices
are:
n DEVICES—Shows all devices attached to the controller
n DISKS—Shows all disks attached to the controller
EMU
Displays information regarding the status of the environmental monitoring
unit (EMU).
storageset-name
Specifies the name of a particular storageset to be displayed. For
example, SHOW STRIPE1 displays information about the stripeset
named STRIPE1.
storageset-type
Specifies the type of storageset to be displayed. Valid types are:
n FAILEDSET—Shows the failedset configured to the controller.
n MIRRORSETS—Shows all mirrorsets configured to the controller.
n RAIDSETS—Shows all RAIDsets configured to the controller.
n SPARESET—Show the spareset configured to the controller.
n STORAGESETS—Shows all storagesets configured with the
controller.
n STRIPESETS—Shows all stripesets configured to the controller.
unit-number
Specifies the name of a particular unit to be displayed. For example,
SHOW D102 displays information about the unit named D102.
UNITS
Displays information for all units configured to the controller.
In addition to the unit name you defined for the unit, the information
includes the unique 128-bit subsystem unit ID. This ID consists of the
controller node ID plus a 64-bit unit ID generated by the subsystem.
You name the units, however, the subsystem identifies them internally
using this identifier.
A unit on controller 1234 5678 9ABC EF00 would have an ID like the
following: