HP Array Controller HSG V8.7 Software - Manual (Page 464)

D–30 HSG80 User’s Guide
03D6450A
During device initialization, the device reported the SCSI Sense Key
MEDIUM ERROR. This indicates that the command terminated with a
non-recovered error condition that was probably caused by a flaw in the
medium or an error in the recorded data. This sense key may also be
returned if the target is unable to distinguish between a flaw in the
medium and a specific hardware failure (HARDWARE ERROR sense
key).
41
03D7450A
During device initialization, the device reported the SCSI Sense Key
HARDWARE ERROR. This indicates that the target detected a non-
recoverable hardware failure (for example, controller failure, device
failure, parity error, etc.) while performing the command or during a self
test.
41
03D8450A
During device initialization, the device reported the SCSI Sense Key
ILLEGAL REQUEST. Indicates that there was an illegal parameter in
the command descriptor block or in the additional parameters supplied
as data for some commands (FORMAT UNIT, SEARCH DATA, etc.). If
the target detects an invalid parameter in the command descriptor block,
then it shall terminate the command without altering the medium. If the
target detects an invalid parameter in the additional parameters supplied
as data, then the target may have already altered the medium. This sense
key may also indicate that an invalid IDENTIFY message was received.
41
03D9450A
During device initialization, the device reported the SCSI Sense Key
UNIT ATTENTION. This indicates that the removable medium may
have been changed or the target has been reset.
41
03DA450A
During device initialization, the device reported the SCSI Sense Key
DATA PROTECT. This indicates that a command that reads or writes the
medium was attempted on a block that is protected from this operation.
The read or write operation is not performed.
41
03DB450A
During device initialization, the device reported the SCSI Sense Key
BLANK CHECK. This indicates that a write-once device encountered
blank medium or format-defined end-of-data indication while reading or
a write-once device encountered a non-blank medium while writing.
41
03DC450A
During device initialization, the device reported a SCSI Vendor Specific
Sense Key. This sense key is available for reporting vendor specific
conditions.
41
03DD450A
During device initialization, the device reported the SCSI Sense Key
COPY ABORTED. This indicates a COPY, COMPARE, or COPY AND
VERIFY command was aborted due to an error condition on the source
device, the destination device, or both.
41
Table D–1 Instance Codes (Continued)
Instance
Code
Description Template