HP Array Controller HSG V8.7 Software - Manual (Page 478)

D–44 HSG80 User’s Guide
01992088 An error was detected by the PLX.
n Last Failure Parameter [0] contains the value of read diagnostic register 0.
n Last Failure Parameter [1] contains the value of read diagnostic register 1.
n Last Failure Parameter [2] contains the value of write diagnostic register 0.
n Last Failure Parameter [3] contains the value of write diagnostic register 1.
n Last Failure Parameter [4] contains the IBUS address of error register.
n Last Failure Parameter [5] contains the PLX status register.
n Last Failure Parameter [6] contains the previous PDAL address of error register.
n Last Failure Parameter [7] contains the RIP.
02010100 Initialization code was unable to allocate enough memory to set up the send data
descriptors.
02040100 Unable to allocate memory necessary for data buffers.
02050100 Unable to allocate memory for the Free Buffer Array.
02080100 A call to EXEC$ALLOCATE_MEM_ZEROED failed to return memory when
populating the disk read DWD stack.
02090100 A call to EXEC$ALLOCATE_MEM_ZEROED failed to return memory when
populating the disk write DWD stack.
020C0100 A call to EXEC$ALLOCATE_MEM_ZEROED failed to return memory when
populating the miscellaneous DWD stack.
02100100 A call to EXEC$ALLOCATE_MEM_ZEROED failed to return memory when
creating the device services state table.
02170100 Unable to allocate memory for the Free Node Array.
021D0100 Unable to allocate memory for the Free Buffer Array.
021F0100 Unable to allocate memory for WARPs and RMDs.
02210100 Invalid parameters in CACHE$OFFER_META call.
02220100 No buffer found for CACHE$MARK_META_DIRTY call.
02270104 A callback from DS on a transfer request has returned a bad or illegal DWD status.
n Last Failure Parameter [0] contains the DWD Status.
n Last Failure Parameter [1] contains the DWD address.
n Last Failure Parameter [2] contains the PUB address.
n Last Failure Parameter [3] contains the Device Port.
Table D–3 Last Failure Codes (Continued)
Code Description