HP Array Controller HSG V8.7 Software - Manual (Page 200)

5–4 HSG80 User’s Guide
6. Disconnect the hub cables from the controller.
Note One or two hub cables may be attached, depending on the
configuration.
7. If connected, disconnect the PC or terminal from the controller’s
maintenance port.
8. Disengage both retaining levers and remove the controller, then place
the controller into an antistatic bag or onto a grounded antistatic mat.
Installing the Controller in a Single Controller
Configuration
Use the following steps to install the controller:
Caution ESD can easily damage a controller. Wear a snug-fitting,
grounded ESD wrist strap.
Make sure you align the controller in the appropriate guide rails. If you
do not align the module correctly, damage to the backplane can occur.
1. Insert the new controller into its slot, and engage its retaining levers.
2. Connect the hub cables to the new controller.
Note One or two hub cables may be attached, depending on the
configuration.
3. Connect a PC or terminal to the controller’s maintenance port.
4. Hold the reset button while inserting the program card into the new
controller. Release the reset button and replace the ESD cover.
5. When the CLI prompt reappears, display details about the controller you
configured. Use the following command:
SHOW THIS_CONTROLLER FULL
See the SHOW THIS_CONTROLLER FULL on page B–145 for more
information about using this command.