HP Array Controller HSG V8.7 Software - Manual (Page 145)

Creating Storagesets 3–67
Changing Device Switches
Use the SET command to change the device switches. For example, the
following command enables DISK10000 to be used in a non-
StorageWorks environment:
SET DISK10000 TRANSPORTABLE
The TRANSPORTABLE switch cannot be changed for a disk if the
disk is part of an upper-level container. Additionally, the disk cannot be
configured as a unit if it is to be used as indicated in this example.
Changing Initialize Switches
The Initialize switches cannot be changed without destroying the data
on the storageset or device. These switches are integral to the
formatting and can only be changed by reinitializing the storageset.
Initializing a storageset is similar to formatting a disk drive; all data is
destroyed during this procedure.
Changing Unit Switches
Use the SET command to change Unit switches that are associated with
a unit. For example, the following command enables write protection
for unit D100:
SET D100 WRITE_PROTECT